NAD T514 - Manual (Page 26)

26
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
Reference
TROUBLESHOOTING
Check the following guide for the possible cause of a problem before contacting service.
SYMPTOM
No power.
The power is on, but the DVD player does not
work.
No picture.
No sound.
The DVD player does not start playback.
The remote control does not work properly.
CAUSE
• The power cord is disconnected.
• No disc is inserted.
• The TV is not set to receive DVD signal output.
• The video cable is not connected securely.
• The equipment connected with the audio cable
is not set to receive DVD signal output.
• The power of the equipment connected with the
audio cable is turned off.
• The AUDIO options are set to the wrong
position.
• An unplayable disc is inserted.
• The rating level is set.
• The remote control is not pointed at the remote
sensor on the DVD player.
• The remote control is too far from the DVD
player.
CORRECTION
• Plug the power cord securely into the mains
socket.
• Insert a disc. (Check that the DVD or, audio CD
indicator in the display window is lit.)
• Select the appropriate video input mode on
the TV.
• Connect the video cable securely.
• Select the correct input mode of the audio
receiver so you can listen to the sound from the
DVD player.
• Turn on the equipment connected with the
audio cable.
• Set the Digital Audio Output to the correct
position, then turn on the DVD player again by
pressing POWER.
• Insert a playable disc. (Check the disc type, color
system, and regional code.)
• Cancel the rating function or change the rating
level.
• Point the remote control at the remote sensor of
the DVD player.
• Operate the remote control closer to the DVD
player.
T514C_NAD_English_Finalv5.1.qxd 2/24/2005 11:18 AM Page 26