NAD T514 - Manual (Page 11)

11
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
Installation and Setup
AUDIO CONNECTION TO OPTIONAL EQUIPMENT
Connect the DVD player to your optional equipment for audio output.
Amplifier equipped with 2-channel analogue stereo or Dolby Pro
Logic ll / Pro Logic
Connect the left and right AUDIO OUT jacks on the DVD player to the
audio left and right IN jacks on your amplifier, receiver, or stereo system,
using the audio cables (A).
Amplifier equipped with 2-channel digital stereo (PCM) or audio
/ video receiver equipped with a multi-channel decoder (Dolby
Digital™, MPEG 2, or DTS)
1 Connect one of the DVD Player’s DIGITAL AUDIO OUT jacks
(OPTICAL O or COAXIAL X) to the corresponding in jack on your
amplifier.
2 Use an optional digital (optical O or coaxial X) audio cable.
DIGITAL MULTI-CHANNEL SOUND
A digital multi-channel connection provides the best sound quality. For
this you need a multi-channel audio / video receiver that supports one
or more of the audio formats supported by your DVD player such as
MPEG 2, Dolby Digital and DTS. Check the receiver manual and the
logos on the front of the receiver.
NOTES
• If the audio format of the digital output does not match the
capabilities of your receiver, the receiver produces a strong, distorted
sound or no sound at all.
• Six Channel Digital Surround Sound via a digital connection can only
be obtained if your receiver is equipped with a Digital Multi-channel
decoder.
• To see the audio format of the current DVD in the on-screen display,
press AUDIO.
CONNECTIONS
Amplifier (Receiver)
Rear of DVD player
A X O
R L
AUDIO INPUT DIGITAL INPUT
OPTICAL COAXIAL
T514C_NAD_English_Finalv5.1.qxd 2/24/2005 11:18 AM Page 11