NEC 2000 - Manual (Page 41)

Configuring the System 3-5
!
Security  Use this menu to set User and Supervisor Passwords,
security mode, password on boot, network boot, and virus check.
!
Power — Use the Power Menu to set power management parameters
such as power savings, auto suspend timeout, hard disk timeout, and
system switch.
!
Boot — Use this menu to set boot options, including restore on
ac/power loss, set boot sequence, and assign drive letters to removable
devices.
!
Exit  Exits the Setup Utility with various save or discard options.
Use the keys listed in the legend bar on the bottom of the Setup Menu to
make the selections or exit the current menu. The following table
describes the legend keys.
Setup Key Functions
Key Function
F1 Provides help for the parameter field
being displayed.
Esc Exits the menu.
Up or down arrow keys Moves cursor up and down for item
selection.
Left or right arrow keys Selects next menu.
-/+ keys Changes values.
Enter Executes a command or selects
submenu.
F9 Loads the default configuration values
for the current menu.
F10 Saves the current values and exits
Setup.
To select one of the six menus from the menu bar, use the left and right
arrow keys. Use the up or down arrow keys to select an item under the
menu.