NEC 2000 - Manual (Page 40)

3-4 Configuring the System
BIOS Setup Utility
The BIOS Setup Utility lets you configure the main components of your
system. The utility is resident in the system FLASH memory and does not
require a diskette or an operating system present to run.
Your system ships from the factory with the correct system parameters for
your configuration. Unless you add optional hardware, you do not need to
run the BIOS Setup Utility to operate your system. However, you might
wish to run the BIOS Setup Utility to set features that customize your
system, such as security features.
NECC recommends that you print out or write down your current BIOS
Setup parameters and store the information in a safe place. This lets you
restore your system to the current parameters if you need to have the
CMOS battery replaced.
How to Start Setup
To start the BIOS Setup Utility, follow these steps.
1. Turn on or reboot the system.
2. Press F2 at the NEC startup screen.
!
You have about five seconds to press F2 .
!
Setup’s Main Menu window appears.
How to Use Setup
The Setup utility has a Main Menu window and six top-level menus with
submenus. The menu bar at the top of the Main Menu window lists the
following top-level menus.
!
Main  Use the Main Menu for basic system configuration. For
example, select Main to set the system date, set diskette and hard disk
parameters, check memory parameters, or set the processor serial
number feature.
!
Advanced  Use the Advanced Menu to set the system for plug and
play, PCI configuration, serial port and printer port addresses and
interrupts, memory cache configurations, I/O device configuration,
DMI event logging, and more.