NEC A1160 - Manual (Page 59)

Components on the Rear of a Cell
A-3
Figure A-1 Rear of the Cell
Table A-2 Component on the Rear of the Cell
Component Description
PCIe carrier/cards Six hot-plug switched PCIe 8x card slots. Slots 1 and 4 can
support full-length cards. Each PCIe card is housed in an
individual carrier.
Cell ID An LED that is lit when the ID button on the
EXPRESSSCOPE® Monitor is pressed. Press the cell ID
button on the rear of the cell to turn off the light.
Partition USB ports Two universal serial bus (USB) 2.0 ports.
Management serial port A 9-pin serial port for the management board.
Partition serial port A 9-pin serial port for the operating system.
Maintenance LAN port An RJ45 port that provides a 10/100 Mbps Ethernet network
connection to the maintenance LAN.
Partition video port A 15-pin SVGA port.
USB management port A USB 2.0 port for use with the management board.
Partition LAN ports Two RJ45 ports that provide 10/100/1000 Mbps Ethernet
network connections for the operating system. These ports
are typically connected to the public LAN.
Navigation buttons Enables the selection of EXPRESSSCOPE® Monitor menu
options.