Nautilus TREADCLIMBER TC916 - Manual (Page 52)

2
CONSOLE COdES
Select Stats:
• Press [ENTER], then use the [Speed: UP] and [Speed: DOWN] keys to select which statistic
you would prefer to scroll on the display during a workout.
Max Speed:
• Press [ENTER], then use the [Speed: UP] or [Speed: DOWN] keys, or numerical keypad to
select preferred speed. Then press [ENTER].
Enable Magnet Key:
• Press [ENTER], then use the [Speed: UP] or [Speed: DOWN] to toggle the Magnet Enable
“ON’ or “OFF”. Then press [ENTER].
Auto Stop:
• Currently not available.
Reset Defaults:
• This code will reset all exercise parameters to the factory defaults. Press [ENTER], to
accept the default values.
3. To exit “CUSTOMIZE”, press the [CLEAR] key.
machine status codes
To view maintenance information such as the run time in hours, number of workouts and
distance, as well a machine type and software revision:
1. Press [Speed: UP], [4], [ENTER]. The console will display “MACHINE STATUS”.
2. Press [Speed: UP] or [Speed: DOWN] to scan through the choices to select the options you
want to view. Press [CLEAR] to exit the machine status codes.
The machine status options are as follows:
Machine run time in hours:
• Display the machine run time in hours. The console will display
“RUN HOURS #####”.
Number of workouts:
• Display the number of times a workout key has been pressed. The console will display
“WORKOUTS ####”.
Distance traveled:
• Display the total distance traveled in miles (or kms if console is set to Metric units). The
console will display “DISTANCE #####”.