Make calls, Data and fax calls – Nokia 2125 User Manual
Page 42

S e t t i n g s
32
Copyright © 2005 Nokia. All rights reserved.
4. Select one of the following
sequence types:
Access no. + phone no. + card no.
—
Dial the 1-800 access number,
phone number, then enter the card
number (plus PIN if required).
Access no. + card no. + phone no.
—
Dial the 1-800 access number, card
number (plus PIN if required), then
enter the phone number.
Prefix + phone no. + card no.
—Dial
the prefix (numbers that must
precede the phone number) and
phone number, then enter the card
number (plus PIN if required).
5. Enter the required information
(access number or prefix and card
number), and select
OK
to confirm
your entries.
6. Select
Card name
, enter the card
name, and select
OK
.
Make calls
After you have saved your calling card
information in your phone, make a call
with your calling card.
1. In the standby mode, select
Menu
>
Settings
>
Call settings
>
Calling card
.
2. Enter your security code, and
select
OK
. See “
”, p.
3. Scroll to the calling card of your
choice, select
Options
>
Select
>
OK
.
4. Press the end key to return to
standby mode, and enter the phone
number, including any prefix
(such as 0 or 1) that your calling
card may require when you make a
calling card call. See your calling
card for instructions.
5. Press and hold the call key for a few
seconds until
Card call
is displayed.
6. When you hear the tone or system
message, select
OK
.
Data and fax calls
Data or fax calls is a network service.
See "
", p.
If your wireless network operator
supports this feature, you can set up
the device to send or receive data or
fax calls when a terminal, such as a
PDA or PC, is connected.
For better performance during data
calls, place the device on a stationary
surface. Do not move the device by
holding it in your hand during a data
call.
For more information on connectivity,
see the PC/PDA Connectivity Guide.
The PC/PDA Connectivity Guide can be
downloaded from the Nokia web site
1. In the standby mode, select
Menu
>
Settings
>
Call settings
>
Data/
fax calls
>
Incoming data/fax call
and one of the following options: