Niles Audio SI-2125 - Manual (Page 15)

14
INSTALLATION AC Power Plug
STeP
Plug the female IEC socket of
the supplied AC cord into the IEC
receptacle on the rear of the amplifier.
Plug the two-prong plug into
120V 60 Hz wall outlet.
CAUTION! Typically the preamp/
receiver’s switched outlet
is not rated for a power amplifier.
Just like a computer or printer, the SI-2125
has an Ac cord which unplugs either at the
amp or at the wall for your convenience.
If you use a grounded power strip, surge
suppressor or extension cord, verify that
proper ground is maintained.
the SI-2125 draws a maximum of
approximately 700 watts from an Ac
wall outlet. use the auto turn on circuit
instead.