NEC MT820 - Manual (Page 30)

Provides access to Lamp Usage information and the Auto Start and Power Management
features. Use the “Select” button on the projector cabinet or (▲) (▼) buttons on your remote
control to access a submenu. Then press “Adjust” (+) or (–) to choose a specific option.
Lamp Usage
This tells you how long the lamp has been in operation. It is recommended that you replace a
lamp after 2000 hours of service. After you install a new lamp, select this icon and press and
hold the “Power On” button on the remote control for ten seconds to reset the lamp clock back
to zero.
NOTE: The projector will turn off and go into stand by mode after 2100 hours of service. If this
happens, press the "Power Off" button on the remote control for ten seconds to reset the lamp clock
back to zero. Do this only after replacing the lamp.
Auto Start
Turns the LCD projector on automatically when the main power switch is turned on. This
eliminates the need to always use the “Power” button on the remote control or projector
cabinet. Press (+) to turn this feature on and (–) to turn it off.
Power Menu
Power Management
When “Power Off” is on and there is no RGB video input for five minutes or more, the
projector will automatically turn itself off. Press the (+) to turn this feature on and (–) to turn
it off. This feature does not work with Video or S-Video sources.
OPERATION
57
58