Nikon DLP 837 Series - Manual (Page 73)

Appendices 73
Reset Name When to Use How to Use Resulting Action
A/V Reset
(for all inputs) To reset audio and
video adjustments for
all inputs to the original
factory settings. While viewing the TV, press the
control-panel buttons ACTIVITY and
VOLUME DOWN at the same time. All Audio and Video settings are
returned to the original factory
settings, including Listen To,
Language, audio Balance,
Closed Captions, Format and
Advanced Picture settings.
Channel
Memorization To erase and
re-memorize channels
on the ANT input. While viewing the TV, press 1.
MENU to display the main menu.
Navigate to the
2. Initial> Channel
menu.
Press
3. ENTER.
Highlight the reception mode, 4.
e.g. Ant Air.
Highlight
5. Scan.
Press 6. ENTER to start channel
memorization.
All previously memorized chan-
nels for the antenna input are
erased and a new set of memo-
rized channels is created. To add
or delete individual channels, see
Initial > Channel > Edit menu
instructions on page 39 .
Lock Menu
Pass Code To change your Lock
menu pass code See the cutout page from Appendix A ,
page 57 . Allows establishment of a new
code.
Control-Panel
Lock Release To re-enable the
control-panel buttons
after activation of the
Control-Panel Lock Press and hold the ACTIVITY button
on the control panel for over eight
seconds. This works even if the TV
is powered off. Allows the control panel to be
unlocked if the remote control is
misplaced.
Auto Input
Sensing for
HDMI When connecting an
HDMI device does
not trigger Auto Input
Sensing. Disconnect the HDMI device. 1.
Delete the HDMI input in the 2.
Inputs > Name menu (see page
40 ).
Power on and connect the new
3.
device.
The New Device Found screen
will display.
System Reset If the TV does not turn
on or off, does not
respond to the remote
control or control-
panel buttons, or has
audio but no video. Press and hold the POWER button on
the control panel for ten seconds. The TV will turn off and the green
LED will flash quickly for about
one minute. When the green
LED stops flashing, you may turn
on the TV. The changes you
made most recently, before using
SYSTEM RESET, may be lost.
TV Reset
IMPORTANT:
Use this reset
only if all other
resets have been
unsuccessful. To reset all consumer-
accessible settings
and all memories to
the original factory
defaults.
CAUTION: All owner-
performed setups and
adjustments will be
erased.
While viewing the TV, press 1.
MENU to display the TV main
menu.
With the main menu displayed,
2.
press number keys 1 2 3 to
display the Reset menu.
READ THE ON-SCREEN
3.
WARNING AND INSTRUC-
TIONS.
If you do not wish to use this •
reset, press BACK or MENU to
back out.
If you do wish to use the •
reset, press ENTER to erase
all memories and settings.
The TV will start the initialization
process. The TV will then turn
off and the front green LED will
start flashing. When the LED
stops flashing, you can turn on
the TV again. All memory and
settings outlined in this Owner’s
Guide will need to be set again.
Appendix E: Troubleshooting, continued