Nikon DLP 837 Series - Manual (Page 52)

52 6. NetCommand Control of an A/V Receiver (837 Series)
IMPORTANT
To hear audio sent from the TV to the A/V receiver,
you must have:
Physically connected the TV to the A/V receiver •
via the analog or digital audio output.
Assigned, if needed, the name AVR if using an •
HDMI A/V receiver.
“ • Learned” the IR codes for the A/V receiver
inputs.
Assigned the TV’s audio output to the correct •
input in the Net Command Inputs > AVR menu.
Selected the A/V receiver as the audio source. •
Press MORE then 9 (AUDIO), then to show
the Speakers option, then to select the A/V
Receiver.
Setting Up A/ V Receiver Control
Pow er and Volume
Perform this setup to control the A/V receiver power
and volume with the TV’s remote control.
To perform this setup you need:
The remote controls for both the TV and the •
A/V receiver.
An IR emitter cable available from Mitsubishi.
•
Before You Begin
Connect your A/V receiver to the TV and any addi- 1.
tional devices. See “Setting Up TV Inputs,” page 10
and “TV Connections,” page 14 .
Connect the IR emitter cable to the TV and position 2.
the IR emitter where it can send signals to the A/V
receiver. See “IR Emitter Placement,” page 46 .
Set the 3. TV’s remote control to TV mode using the
side button.
Setu p to Control A/V Receiver Power and Volume
Open the 1. Inputs > AVR screen in one of two ways:
If using the • New Device Found screen for the
A/V receiver, highlight NetCommand and press
ENTER to open the AVR screen.
If performing Net Command setup at any time •
after Auto Sensing:
Press MENU, highlight Inputs, and highlight AVR
to open the AVR menu.
The first function highlighted in the 2. AVR screen is
always Power. Aim the TV’s remote control at the
TV and press ENTER to begin learning for Power.
Inputs > AVR screen. Perform
Net Command IR “learning” for A/V
receiver power and volume keys.
When the 3. Power text starts flashing, aim the A/V
receiver’s remote control at the TV and hold the
POWER or POWER ON key until a check mark appears
next to Power.
If the text stops flashing before the check mark •
appears, repeat this step.
To remove the key from Net Command control, •
press the CANCEL key while the key name is
highlighted.
Press the 4. key on the TV’s remote control to highlight
other keys in the list. Repeat steps 2 and 3 for each addi-
tional function you wish to control through Net Command.
If the A/V receiver has a separate 5. POWER OFF key,
press on the TV’s remote to highlight Power Off.
Repeat steps 2 and 3 to “learn” the POWER OFF key.
If the device has no POWER OFF key, skip this step.
When finished “learning” the power and volume 6.
keys, either
To watch TV, press • BACK .
To continue with Net Command setup to control •
switching of A/V receiver inputs, highlight
NEXT and press ENTER.