New Media Technology Omnia ONE Multicast - Manual (Page 18)

Rear Panel Connections
Analog Audio Inputs and Outputs
Balanced XLR-type connectors are used as input connectors for the analog audio. Both analog and digital input
sources may be connected simultaneously, however, only the input source that has been selected is active.
Analog/Digital/Livewire Input source selection is done through the “Source” software parameter setting in the
Input/Output / Input Menu.
The stereo analog inputs Individual Left and Right
are designed for standard analog outputs are available
+4dBu balanced signals. on two male XLR jacks.
Pin 2 is Hot. Pin 2 is Hot.
A Note About Relative Phase:
If the relative phase of your installation (including the OmniaONE) differs from that of your existing system, your
announcers may feel that they sound “weird” in their headphones. If this occurs, then the relative phase of the
processor is 180 degrees from what your air talent is used to. To remedy this, you can either reverse the polarity of
both of the analog inputs or simply change the Invert setting to [Both] in the Input submenu of the Input/Output
menu.
OmniaONE Multicast - Use and Operation Manual – Version 0.90
18