NEC 2000 Series - Manual (Page 48)

Configuring the System 3-15
Advanced Menu
Menu Item Settings (default is bold)
I/O Device Configuration Press Enter to access the following
submenus.
Serial Port A Disabled, Enabled, Auto
Setting at Enabled allows the user to
configure the port.
Setting at Auto enables the BIOS or
operating system to configure the port.
Base I/O Address 3F8, 2F8, 3E8, 2E8
Selects the base I/O address for serial
port A.
Interrupt IRQ3, IRQ4
Selects the IRQ for serial port A.
Parallel Port Disabled, Enabled, Auto
Setting at Enabled allows the user to
configure the port.
Setting at Auto enables the BIOS or
operating system to configure the port.
Mode Output Only, Bi-directional, ECP
Selects parallel port mode.
Base I/O Address 378, 278, 3BC
Selects the base I/O address for the LPT
port.
Interrupt IRQ5, IRQ7
Selects the IRQ for the LPT port.