Napoleon Fireplaces TORCH GT8N - Manual (Page 9)

9
W415-0619 / A / 08.09.07
MAINTAIN THESE MINIMUM CLEARANCES TO
COMBUSTIBLES:
Fireplace framing - 6” to top
- 0” to stand-offs (rear and sides)
Fireplace fi nishing - 0”
FIGURE 14
Do NOT use the fi replace if any part has
been under water. Call a qualifi ed service
technician IMMEDIATELY to have the
fireplace inspected for damage to the
electrical circuit.
It is necessary to hard wire this fi replace.
Permanently framing the fi replace with an
enclosure, requires the fi replace junction box
to be hardwired.
This fi replace must be electrically connected
and grounded in accordance with local
codes. In the absence of local codes, use the
current CSA C22.1 CANADIAN ELECTRICAL
CODE in Canada or the ANSI/NFPA 70-1996
NATIONAL ELECTRICAL CODE in the United
States.
ELECTRICAL CONNECTION
HARD WIRING CONNECTION
CLEARANCES TO COMBUSTIBLES
CAUTION
Risk of Electric Shock!
Control and valve
operate with 120v.
FIGURE 15
NAILING TAB INSTALLATION
To install the fi replace face
fl ush with the fi nished surface,
position the framework to
accomodate the thickness of
the fi nished surface. Use 4
self tapping screws to secure
the nailing tabs to the 2 x 4’s.
Cover the nailing tabs with
your fi nishing material.