Napoleon Fireplaces TORCH GT8N - Manual (Page 11)

11
W415-0619 / A / 08.09.07
A. This fi replace is equipped with an ignition device
which automatically lights the burner. Do not try
to light by hand.
B. Before operating, smell all around the fi replace area
for gas and next to the fl oor because some gas is
heavier than air and will settle on the fl oor.
C. Do not use this fi replace if any part has been under
water. Immediately call a qualifi ed service technician
to inspect the fi replace and replace any part of the
control system and any gas control which has been
under water.
When lit for the fi rst time, the fi replace will emit a slight
odour for a few hours. This is a normal temporary condition
caused by the curing of paints and lubricants used in the
manufacturing process and will not occur again. Simply open
a window to suffi ciently ventilate the room.
After extended periods of non-operation such as following a
vacation or a warm weather season, the fi replace may emit a
• Turn off all gas to the fi replace.
• Open
windows.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbour’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fi re
department.
1. STOP! Read the safety information located above.
2. Turn off all electric power to the fi replace.
3. This fi replace is equipped with an ignition device which
automatically lights the burner. Do not try to light by
hand.
4. Remove the glass door.
5. Wait fi ve (5) minutes to clear out any gas. If you smell
gas including near the fl oor STOP! Follow “B” in the
above safety information on this label. If you don’t
smell gas go to the next step.
6. Replace the glass door.
7. Turn on all electric power to the fi replace.
8. Turn the fi replace switch to the ON position.
9. If fi replace will not operate, follow instructions “To
Turn Off Gas” and call your service technician or gas
supplier.
1. Turn the fi replace switch to the OFF position.
2. Turn off all electrical power to the fi replace if service is
to be preformed.
3. Turn manual shut-off valve clockwise to off.
Do not force.
FOR YOUR SAFETY READ BEFORE LIGHTING:
LIGHTING INSTRUCTIONS
TO TURN OFF GAS
WHAT TO DO IF YOU SMELL GAS:
FIGURE 21
slight odour for a few hours. This is caused by dust particles in
the heat exchanger burning off. Open a window to suffi ciently
ventilate the room.
Purge all gas lines with the glass door of the fi replace
open. Assure that a continuous gas fl ow is at the burner
before closing the door.
OPERATING INSTRUCTIONS