NEC 4650N User Manual
Page 104
98
SuperScript 4650 Series — User’s Guide
ALERT Message
Explanation
Booting…
First message to appear when the printer is powered up.
OUT OF PAPER
One of the paper trays is empty
TRAY 2 UNSUPPORTED SIZE
Paper Tray 2 contains paper size that is not supported by the engine.
PAPER MISMATCH LOAD
Paper Tray 1 or 2 does not have the correct paper size as specified for the print
job. Load the paper size shown on the display
Specified Toner Module is empty. Replace it with a new one.
Specified Toner Module is not installed or installed incorrectly. Reinstall it.
PAPER JAM DRUM
Paper jam in Transfer Drum area.
PAPER JAM INNER/DRUM
Paper jam in back transfer area.
PAPER JAM EXIT/DRUM
Paper jam in Output Tray.
MISFEED
Paper misfeed from Paper Tray 1 or Paper Tray 2.
CHECK WASTE TONER
Waste Toner (Toner Collector) is full or is not installed.
REPLACE FUSER OIL
Fuser Oil Bottle needs replacing.
REPLACE FUSER ROLLER
Fuser Cleaning Roller needs to be replaced.
MISPRINT HW FAULT
Printing error caused by no PRREQ-N within a page. Resend the print job.
BELT CARTRIDGE NOT FOUND
Belt Cartridge (OPC) is not installed.
FUSER UNIT NOT FOUND
Fuser Unit is not installed.
FUSER ROLLER NOT FOUND
Fuser Cleaning Roller is not installed.
FRONT COVER OPEN
Front Cover is open.
BACK COVER OPEN
Back Cover (containing Transfer Unit) is open.
TOP COVER OPEN
Top Cover is open.
LOW FUSER OIL
Fuser oil is low. Fuser Unit has about 30 pages of operation remaining.
NEAR END FUSER ROLLER
Fuser Cleaning Roller has about 1000 pages of operation remaining.
REPLACE BELT
Belt Cartridge worn out.
REPLACE FUSER UNIT
Fuser Unit reaches end-of-life.
K-TONER LOW
Black Toner Module has less than 300 pages of operation remaining.
Specified Toner Module has less than 500 pages of operation remaining.
120K SERVICE
Paper Discharger, Drum Cleaner, Transfer Roller, Transfer Drum, and Paper
Pick-up Roller (in back of Paper Trays) all need to be replaced by technician.
CASSETTE OUT
Paper Tray 1 or 2 is not installed in feeder.
MEDIA MISMATCH LOAD
Tray does not have the correct media as specified for the print job. Load the
media shown on the display