Correct assembly incorrect assembly, Grill head installation, Two people are required for this step – Napoleon Grills LD485RB User Manual
Page 19
19
www.napoleongrills.com
4 x N570-0091 (1/4-20 X 1/2”)
3/8”(10mm)
Correct Assembly
Incorrect Assembly
9. Grill Head Installation
PROPANE ONLY – To avoid assembly difficulties, prior to mounting the grill head, remove zip tie holding regulator up under
control panel. This was installed at the factory to protect the regulator hose during shipping and is no longer required.
(Take care when removing the tie not to damage the hose). Ensure the regulator drops into the small opening, between the
tank heat shield and the right side of the cabinet.
Lift grill head and place on assembled cart, lining up holes in top of side cart panels with holes in bottom of base. Fasten
from inside using (4) 1/4-20 x 1/2” screws, two per side.
Two people are required for this step.