Niles Audio SWA-500M - Manual (Page 12)

10
8. Loudspeaker IN Binding Posts: As an alternative to the AUDIO IN jacks, use the
loudspeaker-level, gold-plated, five-way binding posts to connect loudspeaker-level,
stereo audio signals from a home theater receiver or whole-home audio system. Use
this connection only if your home theater receiver does not have a subwoofer, LFE or
pre-amp output.
NOTE: DO NOT USE THESE CONNECTIONS WHEN USING THE LINE-LEVEL INPUTS.
9. Loudspeaker OUT Binding Posts: As an alternative to the AUDIO OUT jacks, use the
loudspeaker-level, gold-plated, five-way binding posts to connect loudspeaker-level,
stereo audio signals to drive your front L/R satellite loudspeakers. These signals are
routed through a fixed, 100 Hz (6 dB per octave) high-pass filter and the response will
be contoured accordingly.
NOTE: THERE WILL ONLY BE A SIGNAL ON THESE CONNECTIONS IF THE LOUDSPEAKER IN
BINDING POSTS ARE USED.
10. Subwoofer A and B Binding Posts: Use these to connect one or two subwoofers. Be
sure that the Speaker Switch (see #4) is set correctly before turning on the amplifier
or damage could result.
11. Detachable IEC Power Cord. If needed, replace the fuse with same type as follows.
12. Main power switch.