Nortel Networks NORSTAR P0886634 - Manual (Page 33)

Installing the DFC on systems equipped with a BIC 27
P0886634 Issue 1.0 FAX Installation Guide
Enabling the FAX software
The FAX option must be enabled after installing the DFC.
After FAX capability has been added to Norstar Voice Mail, you can add or
customize Fax Overflow and Fax-on-demand information. For more information
about customizing the FAX software, refer to the Norstar Voice Mail FAX Set Up
and Operation Guide.
1. Insert the FXENABLE diskette into the floppy disk drive.
2. Plug the power cord into the AC outlet and wait for the NAM to boot from the
disk. This takes two to three minutes.
3. When all disk activity has ceased and the light on the floppy disk drive goes
out, unplug the NAM and remove the FXENABLE diskette from the floppy
disk drive.
4. Replace the front cover. Insert the tongues on the bottom of the front cover
into the module slots.
5. Fasten the two screws holding the front cover to the module.
6. Close the module door. To lock the door, turn the lock 90° clockwise until the
screwdriver slot is horizontal.
7. Plug the power cord into the AC outlet.