Nortel Networks NORSTAR P0886634 - Manual (Page 28)

22 Installing the DFC on systems equipped with a BIC
FAX Installation Guide P0886634 Issue 1.0
Re-installing the BIC in the NAM
Before you begin to install the BIC, ensure you use an antistatic strap to ground
yourself.
To re-install the BIC:
1. Ground yourself by attaching one end of the grounding strap to your wrist and
the other end to a grounded metal surface.
2. Locate expansion slot 2 for a NAM II and slot 4 for a new NAM.
3. Gently push the large ribbon cables leading to the SBC flat against the
backplane. This allows for easier installation of the BIC.
4. Carefully hold the BIC along the top. Insert the card by aligning it between
the metal groove on one side and the slot opening on the other side.
Figure 16 Re-installing the BIC in a NAM II
Slot 2 BIC