Primera Technology III - Manual (Page 8)

Rear Panel
This illustration shows the input ports found on the rear panel
of the Publisher:
The FireWire (IEEE 1394) Port receives data that is to be passed
on to the recording drive.
The USB Interface is connected to an open USB port on your
computer with a standard USB cable, included with your
Publisher.
The
Power Input Port connects to the included 100V~240V 12V
switching power supply.
D. SYSTEM REQUIREMENTS
Before getting started, it is important for you to verify that your
computer meets the recommended system requirements. Here's
what you need in order to successfully burn and print with the
Discribe software:
• G4 PowerPC 700MHz or higher running OS X version 10.2
or higher
• 256MB RAM
• Free hard drive space of at least 2 GB (up to 6 GB for DVD)
• Available USB and FireWire Ports
• Do not connect the Bravo to any USB hubs or the USB port
on your keyboard. It should be connected directly to an on-
board USB port.
• For optimal performance Primera recommends other
FireWire peripherals not be attached to the Mac when using
the Bravo to duplicate discs. Secondarily, source data must
be burned from a local hard drive and/or another internal
CD/DVD drive.
If your computer does not have at least these minimum system
requirements, system performance may not be acceptable.
4 Getting Started
IEEE 1394
FireWire Port
USB Port Power Input Port
510701a.qxd 11/18/03 3:14 PM Page 4
TOC INDEX