beautypg.com

0 ip dslam management, 0 additional information – Paradyne IP DSLAM Multiplexer Module MUM200-2 User Manual

Page 3

background image


Verify the connection: the Lnk (link) LED on the UIM-DS3 and UIM-E3 faceplate will flash green
to indicate a network connection has been established.

For further information refer to the Installation Instructions for each individual UIM model.


2.0 IP DSLAM MANAGEMENT

The MUM200-2 provides IP DSLAM management capability via Net to Net's web-based Network
Management System (NMS) and a scaled-down version of Simple Network Management Protocol (SNMP).
For access and configuration instructions, refer to Net to Net's NMS Management User Guide.


3.0 ADDITIONAL INFORMATION

3.1 LED Indications


LED

State

Indication

Additional Information

PWR
(Power)

solid green

MUM200-2 is receiving
power

Both IP DSLAM power terminals are connected.

solid amber MUM200-2 is receiving

power

One of the two IP DSLAM power terminals are
connected.

no
illumination

no power

The MUM200-2 is not receiving power (the IP
DSLAM may not be receiving power either).

Fan

no
illumination

all fans are functioning

All four of the fans on the IP DSLAM fan card are
functioning.

solid amber non-functioning fan

One or more of the four fans on the IP DSLAM fan
card are no longer functioning.

Lnk (Link)

solid green

direct Ethernet
management connection is
established

The Lnk LED applies only to direct physical
connections with the MGMT port; it does not
apply to uplink network connections.

The MGMT Ethernet port runs at 10 Mbps and
Half Duplex.

no
illumination

no direct connection via
the MGMT port is
established

UIM Lnk
(Link)

solid green

UIM-10/100 Ethernet
uplink connection is
established

For further information regarding UIM-10/100
LEDs, please refer to the corresponding UIM
Installation Instructions.

flashing
green

UIM-T1/E1 or UIM-DS3/E3
uplink connection is
established

For further information regarding UIM-T1/E1 or
UIM-DS3/E3 LEDs, please refer to the
corresponding UIM Installation Instructions.

no
illumination

no uplink connection is
established

Applicable to all UIM models types.

220-0000069 rev 04