Pioneer S-GX3V - Manual (Page 8)

Connecting up 02
8
En
External FM antenna
Use a PAL connector to hook up an external
FM antenna.
Connecting to your TV
This system offers three types of video
connections. If your TV has component video
inputs, see
Connecting using component video
below.
1 Use the supplied yellow video cable to
connect the VIDEO OUT jack to a video input
on your TV.
For a better image, you can also use a
commercially available S-Video cable to
connect the
S-VIDEO OUT jack to an S-Video
input on your TV.
2 Optionally: Use a stereo audio cable to
connect the audio outs of your TV (or VCR) to
the LINE IN jacks on the rear of this unit.
This will enable you to hear the TV (or VCR)
sound through this system. See
Connecting
auxiliary components below for more on this.
Connecting using component video
If your TV has component video inputs, you can
use these instead of the standard or S-Video
output to connect this system to your TV.
1
This
should give you the best quality picture from
the three types of video output available.
• Use a component video cable to connect
the COMPONENT VIDEO OUT to a set of
component inputs on your TV.
About progressive scan video
Compared to interlace video, progressive scan
video effectively doubles the scanning rate of
the picture, resulting in a very stable, flicker-
free image. Progressive scan video is available
only from the component video output.
Important
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the system to progressive, you will not be
able to see any picture at all. In this case,
press
STANDBY/ON to put the system
in standby, select the interlace setting in
the
System Setup menu options in standby
on page 33, then press ENTER
....
AM LOOP
ANTENNA FM UNBAL
75 Ω
ANTENNA
PAL connector
VIDE
O
S-VIDE
O
Note
1 The component video output is switchable between interlaced and progressive formats. See Video Output settings on page 29.
COMPONENT
VIDEO
P R
P B
Y
VIDE
O
XV-GX3.book 8 ページ ２００５年７月６日 水曜日 午前１１時４２分