Philips DC200/79 - Manual (Page 7)

5 Press PROG/SET TIME to confirm.
6 In clock mode, press ALBUM/PRESET -/+
1 /2 to set your time zone.
7 To zoom in/out the clock display, press MODE in clock mode.
TUNER
1 Press SOURCE repeatedly to switch on the radio (FM only).
™ Display shows the radio frequency of the last selected waveband. Your pre-
set station is also shown if you are listening to a preset. (See 2)
2 Adjust the sound using VOLUME 3 /4.
3 To select preset stations, press ALBUM/PRESET -/+ 1 /2 once or repeatedly.
TUNING TO RADIO STATIONS
1 Press and hold
¡1 / 2™ until the frequency in the display starts changing.
™ After the system tunes to a station of sufficient reception, display shows its
frequency.
• To tune to a weak station, press ¡1 / 2 ™ briefly and repeatedly until an
optimal reception is found.
To improve reception (FM):
Extend and position the pigtail fully to obtain optimum reception.
STORING AND USING PRESET STATIONS
You can store up to 20 FM radio stations in the memory.
1 Tune to your desired station (see TUNING TO RADIO STATIONS).
2 Press PROG to activate the programming, and then press ALBUM/PRESET -/+
1
/ 2 to select a desired preset number.
3 Press PROG again to confirm.
4 Press ALBUM/PRESET -/+
1 / 2 to listen to a preset station.
AUTOSTORE: Automatic programming
1 Press and hold PROG for more than two seconds.
™Available radio stations will be automatically stored.
DC200_79_CCR 2008.2.21 17:01 Page 7