Philips DC200/79 - Manual (Page 6)

POWER SUPPLY
Mains adaptor
1 Connect the mains adaptor to the set's DC 9V socket and to the power socket.
Helpful hints: To avoid damage to the set, use only the adaptor supplied!
The power rating is located on the bottom of the set.
SELF-POWERED BACK-UP
The self-powered back-up conveniently allows your alarm and clock time settings to be
stored for up to 10 minutes when there is a power interruption e.g. AC power failure.
The complete clock radio and backlight illumination will be switched off.
If power supply returns after 10 minutes and the display shows:
• clock time blinking - indicates you need to re-adjust the clock time.
BASIC OPERATION.
Switching on the system
• Press POWER.
™ The system will switch to the last selected source.
Switching the system to standby mode
• In any source mode, press POWER.
Illumination brightness
Press REPEAT ALARM /
BRIGHTNESS CONTROL once or more.
• The brightness of the display can be adjusted:
Bright
➟
Low
➟
Off
➟
Bright .
SETTING THE CLOCK
1 In standby mode, press and hold PROG/SET TIME until clock digits flashes.
2 Hold down or press
¡1 / 2™ repeatedly to set and adjust the hours.
3 Press PROG/SET TIME to confirm.
™ The clock digits for the minutes flash.
4 Hold down or press ¡1 / 2™ repeatedly to set and adjust the minutes.
DC200_79_CCR 2008.2.21 17:01 Page 6