Polycom IP 600 - Manual (Page 32)

29
Modifications
In accordance with Part 15 of the FCC
Rules, the user is cautioned that any chang-
es or modifications not expressly approved by Polycom, Inc. could void the user’s
authority to operate the equipment.
Installation Instructions
Installation must be performed in accor-
dance with all relevant national wiring
rules. L’Installation doit être exécutée confor-
mément à tous les règlements nationaux
applicable au filage électrique.
Plugs Acts as Disconnect Device
The socket outlet to which this apparatus is
connected must be installed near the equip-
ment and must always be readily accessible. La prise électrique à laquelle l’appareil
est branché doit être installée près de
l’équipement et doit toujours être facile-
ment accessible.
Industry Canada (IC)
This Class [B] digital apparatus complies
with Canadian ICES-003. Cet appareil numérique de la classe [B]
est conforme à la norme NMB-003 du
Canada.
Class B Digital Device or Peripheral
Note: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harm-
ful interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interfer-
ence to radio communications. However,
there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
1. Reorient or relocate the receiving
antenna.
2. Increase the separation between the
equipment and receiver.
3. Connect the equipment into an out-
let on a circuit different from that
to which the receiver is connected.
4. Consult the dealer or an experience
radio/TV technician for help.
2. This device must accept any
interferences received, including in-
terference that may cause undesired
operation.