Pioneer DC500 User Manual
Page 99
EN-99
Installing the Flash Link optical cable
a d a p t e r
The Flash Link adapter connects the SeaLife Flash Link optical cable (item # SL962 - optional
accessory) to the DC500 camera. This adapter is only needed when using the SeaLife External Flash
(item # SL960 – optional accessory) or Digital Flash (item # SL960D – optional accessory). It is strongly
recommended to purchase the Flash Link optical cable accessory if you are using a SeaLife external
Flash to ensure it fires all the time.
Step 1: Insert end of Flash Link
optical cable into one of the
adapter holes as shown. Push
cable in all the way until it stops!
Step 2: Use small wrench provided
to tighten set screw until you feel
some resistance. Do not over
tighten! Gently pull on cable to
check that it is firmly attached.