How to install and remove o-ring – Pioneer DC500 User Manual
Page 95
EN-95
HOW TO INSTALL AND REMOVE O-RING
To Install O-ring:
Step 1: O-ring and O-ring groove must be completely
clean before installing O-ring.
Step 2: Push O-ring into groove as shown being careful
not to twist or roll O-ring.
Step 3: Use two fingers to push last part of O-ring into
groove.
Step 4: Carefully close housing to firmly seat O-ring and
open housing again to inspect that O-ring is completely
seated into groove. Do NOT grease the O-ring.