Panasonic KX-TS620W - Manual (Page 54)

54 For assistance, please visit http://www.panasonic.com/phonehelp
Useful Information
Troubleshooting
Problem Cause and Remedy
The unit does not work. • Check the settings (p. 9–15).
• Unplug the AC adaptor to reset. Plug in, and try again.
The unit does not ring. • The ringer volume is set to OFF and “~” is displayed.
Select the ringer volume to HIGH, MID or LOW by
pressing {HOLD/RINGER} (p. 14).
You cannot dial. • Check that the dialing mode selection is correct
(p. 13).
• The dialed number is restricted. To cancel,
see page 42.
The other party
suddenly cannot hear
your voice during a
conversation. • {MUTE} may have been pressed during the
conversation. If “ ” is displayed, press {MUTE}.
You cannot program
items such as the
dialing mode. • Programming is not possible when the handset is off
the cradle, the SP-PHONE/HEADSET indicator lights,
or when viewing caller information.
• Do not pause for over 60 seconds while programming.
You cannot store a
name and phone
number in memory. • Programming is not possible when the handset is off
the cradle or the SP-PHONE/HEADSET indicator
lights.
• Check the AC adaptor is connected to the unit.
• Do not pause for over 60 seconds while storing.
• Do not enter a phone number more than 32 digits long.
• When using the Call Restriction feature (p. 42), you
cannot store a phone number in the Direct Dial
memory ({M1}, {M2} or {M3}) and emergency
numbers (#).
• If “ Phonebook full” is displayed, erase other stored
items from the Phonebook memory (p. 35).
While programming or
searching, the unit
starts to ring and stops
the program/search. • To answer the call, lift the handset or press
{ SP-PHONE/HEADSET}. Start again from the
beginning after hanging up.
TS620bk01.book Page 54 Wednesday, May 24, 2006 2:31 PM