Powerline P2X - Manual (Page 6)

CAUTION: To set up this unit, you will need assistance. Do not attempt assembly by yourself.
You must review and follow the instructions in this Owner’s Manual. If you do not assemble and use the
P2X gym according to these guidelines, you could void the warranty.
Required Tools
The tools that you should obtain before assembling
the P2X gym include:
Rubber Mallet
Screwdriver (standard or phillips)
4mm Allen Key
5mm Allen Key
6mm Allen Key
8mm Allen Key
6mm Open-End Wrench
8mm Open-End Wrench
10mm Open-End Wrench
6” Adjustable wrench
8” Adjustable wrench
6mm Socket and ratchet (optional)
8mm Socket and ratchet (optional)
10mm socket and ratchet (optional)
Installation Requirements
Follow these installation requirements when
assembling the P2X:
surface under the machine helps keep it level. A
level machine has fewer malfunctions.
Provide ample space around the machine. Open
space around the machine allows for easier access.
Insert all bolts in the same direction. For aesthetic
purposes, insert all bolts in the same direction
otherwise.
Leave room for adjustments. Tighten fasteners such
as bolts, nuts, and screws so the unit is stable, but
leave room for adjustments. Do not fully tighten
fasteners until instructed in the assembly steps to
do so.
Fill out and mail warranty card.
CAUTION: Obtain assistance! Do not attempt
to assemble the P2X by yourself. Review the
Installation Requirements before proceeding
with the following steps.
The P2X unit comes in separate boxes.
Be careful to assemble components in the sequence
presented in this guide.
NOTE: With so many assembled parts, proper
alignment and adjustment is critical. While tightening
the nuts and bolts, be sure to leave room for
adjustments.
Preparations
6
Set up the P2X on a solid, flat surface. A smooth, flat
unless specified (in text or illustrations) to do