Planet Technology FNSW-3200 - Manual (Page 16)

- 13 -
5. TROUBLESHOOTING
This chapter contains information to help you solve problems. If
Switch is not functioning properly, make sure the Ethernet
Switch was set up according to instructions in this manual.
The Link LED is not lit
Solution:
Check the cable connection and remove duplex mode of
the Switch.
Some stations can not talk to other stations located on The
other port
Solution:
The address table may contain older information than of the
address table of that node. Please power down to refresh
the address information.
Performance is bad
Solution:
Check the full duplex status of the Ethernet Switch. If the
Ethernet Switch is set to full duplex and the partner is set to
half duplex, then the performance will be poor.