Planet Technology FNSW-3200 - Manual (Page 10)

- 7 -
3. INSTALLATION
The Switch do NOT require software configuration. Users can
immediately use any of the features of this product simply by
attaching the cables and turning on the power.
To get the best use of these Switch models, many things need
to be considered first. See Section 4. OPTIMIZING
CONFIGURATION for details.
3.1 Rack-Mount Installation
Most users prefer to attach the power cord to the hub before
installation in a network rack. Do not plug the other end of the
cord into a power outlet until after the hub is installed.
For mounting the Switch in a network rack, first attach the
rack-mount brackets to the side of the hub with screws. (Both
brackets and screws are included in the product package.) Slide
the hub into the rack and align the holes in the bracket with the
corresponding holes in the network rack. Attach the bracket to
the rack with the enclosed screws.
3.2 Desktop Installation
To locate the Switch on a desktop, first attach the four rubber
feet to the bottom of the hub, one in each corner. Place the hub
on a clean, flat desk or tabletop close to a power outlet. Make
sure there is no hindrance behind the fan of the hub
Plug in all network connections, and then turn the switch on via
plug in the power cord.