Philips SRP620 - Manual (Page 4)

English
CONTENT
Introduction................................................................. 4
Getting started............................................................. 4
Inserting the batteries .............................................. 4
Testing the remote control......................................... 4
Shift Mode .............................................................. 4
DVD/VCR Mode......................................................... 5
Keys and functions .................................................... 5-6
Adjustments to your remote control............................ 6-7
Selecting the right VCR or DVD functions .................... 7-8
Extra possibilities......................................................... 9
Need help? .................................................................. 9
INTRODUCTION
You just made a great choice by buying this Philips remote
control! It can replace any Philips TV remote control
manufactured since 1985.
If you also have a Philips DVD player/recorder, VCR or
Combi TV with build in VCR or DVD player,
you can operate these devices with the SRP620 as well.
GETTING STARTED
A DVICE
Carefully read the complete procedure before starting!
Inserting the batteries
The SRP620 needs two batteries of the type AA/R06 that are
included in the packaging. Open the battery cover and place
the batteries as indicated in the drawing.
Testing the remote control
The SRP620 is programmed to send out the most common
functions used in Philips TVs. As the available functions vary
over the different TV models, you might need to change some
settings in the remote control to be able to control all
TV functions.
First, test all the buttons on the remote and check whether
the TV responds correctly to the commands of the SRP620.
N OTE
- If the TV does not respond correctly or not at all,
go to chapter: ‘Adjustments to your remote control’.
Shift Mode
To access some of the functions you have to use the
SHIFT mode in combination with another key.
For turning on PIP mode e.g., press the Mode key once.
The Shift light starts blinking now. Press the Red button with
the PIP symbol.
The PIP mode will now be activated and the Shift light stops
blinking.
For a description of the functions on the SRP620,
please go to the next chapter.
Instructions for use
4
EnglishEnglishEnglishEnglishEnglishEnglish
SBC_SRP620_v2.qxd 26-04-2005 14:57 Pagina 4