Pioneer AXM-P7650 - Manual (Page 28)

2 Press m or n to select the speaker
to be adjusted.
Each press of m or n selects the speaker
in the following order:
Front speaker leftCenter speakerFront
speaker rightRear speaker rightRear
speaker leftSubwoofer
# You cannot select speakers whose size is set
at OFF.
3 Press q or r to adjust the distance
between the selected speaker and the lis-
tening position.
Each press of q or r increases or de-
creases the distance. 500.0 cm 0.0 cm is dis-
played as the distance is increased or
decreased.
4 Press BAND to return to the playback
display.
Using the auto-equalizer
The auto-equalizer is the equalizer curve cre-
ated by auto TA and EQ (refer to Auto TA and
EQ (auto-time alignment and auto-equalizing)
on this page).
You can turn the auto-equalizer on or off.
1 Press p and hold until SP Set appears
in the display, then press p to select
AUTO EQ.
# You cannot use this function if auto TA and
EQ has not been carried out.
2 Press r to turn the auto-equalizer on.
AUTO EQ ON appears in the display.
# To turn auto-equalizer off, press q.
Auto TA and EQ (auto-time
alignment and auto-
equalizing)
Only when the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you can
operate this function.
The auto-time alignment is automatically ad-
justed for the distance between each speaker
and the listening position.
The auto-equalizer automatically measures
the car interior acoustic characteristics, and
then creates the auto-equalizer curve based
on that information.
WARNING
To prevent accidents, never carry out auto TA and
EQ while driving. When this function measures
the car interior acoustic characteristics to create
an auto-equalizer curve, a loud measurement
tone (noise) may be outputted from the speakers.
CAUTION
! Carrying out auto TA and EQ under the follow-
ing conditions may damage the speakers. Be
sure to check the conditions thoroughly be-
fore carrying out auto TA and EQ.
When speakers are incorrectly connected.
(e.g., When a rear speaker is connected to
a subwoofer output.)
When a speaker is connected to a power
amp delivering output higher than the
speakers maximum input power capabil-
ity.
! If the microphone is placed in an unsuitable
position the measurement tone may become
loud and measurement may take a long time,
resulting in a drain on battery power. Be sure
to place the microphone in the specified loca-
tion.
Digital Signal Processor
En
28
Section
07