Paxar Handi Print 6017 - Manual (Page 26)

A-2 Specifications
Memory: 32K SRAM and 128K Flash
Charging
Time: Approximately 3 hours with no printing
Comm: RS-232 port
Print Ratio: 25% black maximum per square inch
S u p p l y S p e c i f i c a t i o n s
Type: Thermal direct receipt paper
Thickness: 2.2 to 3.5 mils (receipt paper)
Width: 3.125 inches (79 mm)
Length: 1.0 inch (25.4 mm) minimum feed
8.0 inch (203 mm)
1 roll of receipt paper is approximately 600
inches (15,240 mm)
Sensing: Black mark (on the face of the supply)
Roll
Diameters: Inside: .25 inches (6 mm)
Outside: 1.5 inches (38 mm)
Maximum
Print Area: 2.85 inches (72 mm) by 8.0 inches (203 mm)
NOTE: Maximum length depends on format.
O p t i o n s
♦ Magnetic Card Reader (factory-installed)
♦ Printer Stand (120611)
♦ Belt Clip (120296)
♦ Monarch 9462 Single Station Battery Charger
(can be wall-mounted)
♦ Monarch 9464 Four Station Battery Charger
WARNING
Use only the above Monarch chargers designed for
lithium-ion batteries when charging. The battery might
explode if placed on a different charger. To order a
replacement battery, use part number 12009502.