Panasonic CF-30 - Manual (Page 23)

23
Useful Information
12 Turn on the computer, and press F2 several times while [Panasonic] boot screen is dis-
played.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
13 Press F9 .
At the confi rmation message, select [Yes] and then press Enter.
The Setup Utility settings excluding the password(s) will return to the default values.
14 Select the [Exit] menu and then select [Save Current Values], then press Enter .
At the confi rmation message, select [Yes] and press Enter.
15 Turn the computer off by using the power switch.
If additional instructions are included with the computer, be sure to read them. It may be necessary to per-
form additional operations during the following procedure.
16 Perform the fi rst-time operation ( page 13).
17 Start the Setup Utility and change the settings as necessary.
To change the drive letter of hard disk or CD/DVD drive
NOTE
Drive letters of hard disk can be changed only when two or more partitions have been created on the hard disk
drive.
The drive letter for the C: drive cannot be changed.
Change the drive letters before installing applications.
A Click [start] - [Control Panel] - [Performance and Maintenance] - [Administrative Tools], and double-click [Com-
puter Management].
B Click [Disk Management] from [Storage].
C Right-click the hard disk partition or the CD/DVD drive name, and click [Change Drive Letter and Paths...].
D Click [Change...].
E Click [Assign the following drive letter] and the new drive letter, and then click [OK].
At the confi rmation message, click [Yes].
CF-30CTQZZBM.indb 23 CF-30CTQZZBM.indb 23 12/4/2007 10:01:25 AM 12/4/2007 10:01:25 AM