Patton electronic 3087 User Manual
Page 5

Model 3087 Quick Start Guide
5
4.0 Log onto the GUI web management page
You will now access the web management graphical user interface (GUI) to configure the ipRocketLink using a
standard web browser (such as Netscape or Internet Explorer).
1.
At your PC, open a web browser and enter the IP address you assigned to the ipRocketLink’s Ethernet LAN
port in step 2 of
2.2 “Modify the IP address”
.
2.
Log into the web management home page using the username
superuser
and the password
superuser
.
(See
figure 3
.)
Figure 3.
Model 3087 web management home page
5.0 Connect to the G.SHDSL Port
1.
Obtain single-twisted-pair cable with an RJ-11 plug connector at each end.
2.
Plug one end of the cable into the (yellow) RJ-11 socket (labeled
DSL
) on the ipRocketLink Integrated
Access Device.
3.
Plug the other end of the cable into the RJ-11 wall socket that provides your G.SHDSL service.
4.
When a DSL link is established, the front-panel
WAN LINK
LED will turn on.
6.0 Connect the serial port
Your ipRocketLink is equipped with one of the following serial WAN ports for connection to an NTU:
•
V.35 (M/34 or DB-25) – Model 3087/RIC/EUI
•
X.21 (DB-15) – Model 3087/RID/EUI
•
T1/E1(RJ-48C and dual BNC) – Moel 3087/RIC/EUI