Patton electronic 3087 - Manual (Page 3)

Model 3087 Quick Start Guide 3
3. Insert the male plug of the AC power cord into an AC power outlet (mains) (100-240 V AC).
1.3 Power-up indication
The Power LED blinks as the ipRocketLink is powering up. When the Power LED stops blinking and remains lit,
the ipRocketLink is ready for you to configure.
2.0 Configure the IP address
The ipRocketLink is shipped with a factory-configured IP address to the Ethernet LAN port (green outline). The IP
address is 192.168.200.10/24 . In most cases, you must change the address to be on the same subnet
as your PC, as described in the procedures below. If you are not sure which IP address to use for your installa-
tion, contact your network administrator.
2.1 Connect a PC and log in
1. Using the included combination RS-232/Ethernet cable and DB9-RJ45 adaptor, connect a PC’s serial port
to the ipRocketLink’s
Console port (see figure 1 ).
Figure 1. Connecting the ipRocketLink console port to the PC’s RS-232 serial port
2. Start a HyperTerminal (or similar terminal emulation program) session on the PC using the following set-
tings:
9600 bps, 8 data bits, 1 stop bit, no parity, no flow control
3. Log into the ipRocketLink using the factory-default login username and password:
Login: superuser
Password: superuser
Login successful
2.2 Modify the IP address
1. Display current IP interface settings for the ipRocketLink Ethernet LAN port.
Connect to Console port
Serial port
PC with
terminal emulator
Power
Console
ipRocketLink
G.SHDSL
Integrated
Access Device
Model 3086
Link
TD RD CTS DTR
WA N Sync Serial
Link 100M Tx Rx
Ethernet
NS ER TM
Status
- 51 1E
- Normal
- 51 1 Test Modes
Local - Normal -
Remote -