PreSonus DigiMax 96k - Manual (Page 10)

CONTROLS & CONNECTIONS
8 | PreSonus 2007
2.2 BACK PANEL LAYOUT
 Microphone Pre-Amplifier. Your DigiMax 96K is equipped with eight custom designed PreSonus
microphone preamplifiers for use with all types of microphones including Dynamics, Condensers and
Ribbons as well as instruments and line level signals. Each channel of your DigiMax 96k is equipped
with a Class A discrete input buffer followed by a dual servo gain stage. This provides ultra low noise
and wide gain control allowing you to boost desirable signal without increasing unwanted background
noise.
o
48 Volt Phantom Power. The FireStudio Project has 48V Phantom power available in groups of
two via push button switches on the back panel. From right to left, each button activates Phantom
power for channels 1&2, 3&4, 5&6 and 7&8 respectively.
XLR connector wiring for Phantom Power
Pin 1 = GND
Pin 2 = +48V
Pin 3 = +48V
o
+52dB Headroom. The DigiMax 96K microphone preamplifier has +52 dB headroom. This
feature gives you wide dynamic range and excellent transient response characteristics.
 Direct Analog Outputs (TRS Balanced). These are general purpose line-level direct outputs for each
input channel. They are post gain and pre-converter.
 BNC I/O. The BNC I/O allows the DigiMax 96K to be connected and slaved to an external word clock
generator or act as the master clock of your system.
 ADAT Output. This optical ADAT output sends eight channels of digital audio output (24 bit 44.1 /
48kHz). Word clock is also being sent through this output so you can use the DigiMax 96K as a clock
master.
CHANNEL 8 CHANNEL 7 CHANNEL 6 CHANNEL 5 CHANNEL 4 CHANNEL 3 CHANNEL 2 CHANNEL 1
OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT
+48V MIC. IN +48V MIC. IN +48V MIC. IN +48V MIC. IN +48V MIC. IN +48V MIC. IN +48V MIC. IN +48V MIC. IN
WORD
CLOCK
P
O
WE
R
Digital Out
S/PDIF - AES/EBU D
IG
IM
A
X
adat
OUT IN