System cmos issues – Promise Technology 150TX2 User Manual
Page 62
FastTrak S150 TX2plus User Manual
58
System CMOS Issues
Set Motherboard CMOS Boot sequence to boot to FastTrak S150 TX2plus
On some Motherboard BIOS, it is necessary to set the Boot sequence to SCSI,
A:, C: since the Promise card is identified as a SCSI card.
Motherboard CMOS displays C: or D: drive failure during startup
See the Drive-Related Errors section.
Using an Onboard IDE Card with FastTrak S150 TX2plus
If an onboard IDE controller is installed with hard disks, enable support in the
Motherboard Standard CMOS Setup for the drives. Note that the onboard IDE
hard drives will then be the bootable hard disk unless the system BIOS has a
boot sequence setting with the option to specify booting to a different device.