Patton electronic CopperLink Ethernet Booster 2110 - Manual (Page 8)

8
Figure 2. Model diagram (2110/PSE model shown)
3.1 CONNECTING THE POE AND 10/100BASE-T ETHERNET
INTERFACE
The shielded RJ-45 port is the Auto-MDIX10/100Base-T interface. This
port is designed to connect directly to a 10/100Base-T network. Figure 3
shows the signal/pin relationships on this interface. You may connect this
port to a switch, IP camera, hub or PC using a straight through or cross-
over cable that is up to 328 ft long.
Figure 3. Model 2110 10/100Base-T RJ-45 Connector Pinout.
If used externally, interconnecting cables shall be rated
for the proper application with respect to voltage, cur-
rent, anticipated temperature, flammability, and
mechanical serviceability.
Model 2110
(Front and Top)
Model 2110
(Back and Bottom)
Po
E IN
PoE and/or Ethernet
Output
RJ-45 port
PoE and/or Ethernet
Input
RJ-45 port
Power jack
(EUI models only)
CO MP LIE S W ITH PA RT 15 CL AS S A
OF TH E F CC RU LE S.
SE E IN ST AL LA TIO N IN ST RU CT IO NS
BE FO RE CO NN EC TIN G T O S UP PL Y.
___ ___ ___ ___ ___ ___ ___ ___ ___ __
___ ___ ___ ___ ___ ___ ___ ___ ___ __
Pat ton Ele ctro nic s
Ma de i n th e U SA
2110 Model Types:
2110/P - PoE/Ethernet
2110/PSE - PoE/Ethernet
2110/EUI - Ethernet only
Po
E OU
T
Mo
de l 2 11 0/P
SE
Po E & Et he rn et
In je cto r
Ga ith er sb ur g, Ma ryl an d, US A
CAUTION
1 TX+/RX+
2 TX-/RX-
3 RX+/TX+
4 (NC) or PoE
5 (NC) or PoE
6 RX-/TX-
7
(NC)
or PoE
8 (NC) or PoE
1
2
3
4
5
6
7
8