Pioneer VSX-45TX - Manual (Page 79)

79
Using Other Functions
EXPER
T
OUT
IN
CONTROL
OFF S0URCE
Î
TV
MULTI CONTROL
SYSTEM RECEIVER
DVD/LD TV SAT TV CONT
VCR1/ DVR VCR2 VIDEO MULTI OPERATION
CD DIMMER
CD-R/ TAPE1 TUNER RECEIVER
1 INPUT ATT 2 LOUDNESS 3 SPEAKER A/B 4
VIDEO SEL 5 SIGNAL SEL 6 TAPE 2
DIRECT ACCESS DISP MODE
– + + 10 DISC ENTER
7 EFFECT/CH SELL 8 TONE 9 BASS/TREBLE 0
SYSTEM SETUP
TUNER EDIT MENU REMOTE SETUP
STATUS
MPX GUIDE EXIT RETURN
ENTER
¶ TUNING –
STATION
SURROUND LISTENING MODE
–
CHANNEL –
1
4
DTV ON/OFF
TUNING +
+
CHANNEL +
¡
STATION ¢
8
3
7
EXTRA MENU BAND
DTV MENU CLASS
TV INPUT TV CONTROL
TV CH TV VOL VOLUME
INPUT
MIDNIGHT
DIGITAL NR
STEREO
/DIRECT THX MUTE STANDARD
LISTENING
CH SELECT MULTI CH INPUT ACOUSTIC CAL
ADVANCED
CONCERT ADVANCED CINEMA (DVD-A/SACD) LIGHT
SETUP
OUT
IN
CONTROL
• You can also control PIONEER components (and those made by other manufacturers) by pointing the
receiver's remote control directly at the respective component. This type of operation does not re-
quire control cords. All you have to do is recall the appropriate stored settings (see pages 62- 63).
• If you use a remote control hooked up via the CONTROL IN jack with a control cord, you won't be able
to use this unit's remote control.
• If you use this feature make sure an analog (audio and/or video) connection has been made between
the units.
• Remote operation may not be possible if direct light from a strong fluorescent lamp is shining on the
IR receiver remote sensor window.
• The tuner cannot be tuned to more than one station at a time. Therefore, changing the station in one
room also changes the station in the other room. Please be careful not to change stations when
recording a radio broadcast.
• The volume levels of the main and sub rooms are independent.
• When more than one remote control signal is transmitted at the same time, the receiver does not
operate.
• When operating MULTI ROOM & SOURCE with the MULTI ROOM & SOURCE OUT jacks connected
to a sub room amplifier which bears the PIONEER component with an CONTROL terminals and has a
remote sensor, both the IR receiver and the amplifier may receive remote control commands (making
correct operation impossible). In this case, place the IR receiver and amplifier apart from each other,
and point the remote control directly at the IR receiver during operation.
• If you plan to leave the MULTI ROOM feature off for a lengthy period please turn off the power in both
the sub and main rooms. Make sure the STANDBY indicator turns red and the MULTI ROOM indicator
goes off.
• If you send the SYSTEM OFF command from the sub room by remote control, the power of both
rooms will go off. Please be careful when making a recording in the main room.
The PIONEER SR System: Operating other PIONEER
components
Connecting an optional control cord allows you to operate other PIONEER components simply by pointing the
receiver's remote control at the remote sensor on the front panel of the receiver. The receiver then sends the
remote control signals to the other devices via the CONTROL OUT terminal.
memo
Remote Control
Receiver
To CONTROL IN
terminal of another
PIONEER component
with an CONTROL
terminals.
PIONEER component
with an CONTROL
terminals.
memo