Pioneer SUPER TUNERIII DEH-P8650MP - Manual (Page 59)

! 20dB ATT Attenuation (20dB ATT has a
stronger effect than 10dB ATT)
! TEL mute Muting
Settingthe FM tuningstep
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Use MULTI-CONTROL to select FM.
The function name tag FM is highlighted.
2 Press MULTI-CONTROL to select the FM
tuning step.
Pressing MULTI-CONTROL repeatedly will
switch the FM tuning step between 100 kHz
and 50 kHz. The selected FM tuning step will
appear in the display.
Note
Ifseek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.
Settingthe AM tuningstep
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
1,602 kHz allowable) to 10 kHz (530 1,640
kHz allowable).
1 Use MULTI-CONTROL to select AM.
The function name tag AM is highlighted.
2 Press MULTI-CONTROL to select the AM
tuning step.
Pressing MULTI-CONTROL repeatedly will
switch the AM tuning step between 9 kHz and
10 kHz. The selected AM tuning step will ap-
pear in the display.
Switchingthe warningtone
Ifthe front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Use MULTI-CONTROL to select WARN.
The function name tag WARN is highlighted.
2 Press MULTI-CONTROL to turn warning
tone on.
Warning tone :ON appears in the display.
# To turn warning tone off, press
MULTI-CONTROL again.
Usingthe feature demo
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
You can turn the feature demo on or off.
Important
The red lead (ACC) ofthis unit should be con-
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicle
battery may be drained.
1 Use MULTI-CONTROL to select DEMO.
The function name tag DEMO is highlighted.
Initial Settings
En
59
English
Section
11