Pioneer SUPER TUNERIII DEH-P8650MP - Manual (Page 16)

Tuningin strongsignals
Local seek tuning lets you tune in only those
radio stations with sufficiently strong signals
for good reception.
1 Use MULTI-CONTROL to select LOCAL.
The function name tag LOCAL is highlighted.
2 Press MULTI-CONTROL to turn local
seek tuning on.
Local seek sensitivity (e.g., Local 2) appears in
the display.
# To turn local seek tuning off, press
MULTI-CONTROL again.
3 Push MULTI-CONTROL left or right to
set the sensitivity.
There are four levels of sensitivity for FM and
two levels for AM:
FM: Local 1Local 2Local 3Local 4
AM: Local 1Local 2
The Local 4 setting allows reception ofonly
the strongest stations, while lower settings let
you receive progressively weaker stations.
Storingthe strongest
broadcast frequencies
BSM (best stations memory) lets you automa-
tically store the six strongest broadcast fre-
quencies under preset tuning buttons 16 and
once stored there you can tune in to those fre-
quencies with the touch ofa button.
1 Use MULTI-CONTROL to select BSM.
The function name tag BSM is highlighted.
2 Press MULTI-CONTROL to turn BSM on.
Searching begins to flash. While Searching is
flashing the six strongest broadcast frequen-
cies will be stored under preset tuning buttons
16 in the order oftheir signal strength. When
finished, the preset channel list appears.
# To cancel the storage process, press
MULTI-CONTROL.
3 Use MULTI-CONTROL to select the de-
sired station.
Turn to change the station; press to select.
# You can also change the station by pushing
MULTI-CONTROL up or down.
Note
Storing broadcast frequencies with BSM may re-
place broadcast frequencies you have saved
using buttons 16.
Selectingstations from the
preset channel list
The preset channel list lets you see the list of
preset stations and select one ofthem to re-
ceive.
1 Turn MULTI-CONTROL to switch to the
preset channel list mode.
2 Use MULTI-CONTROL to select the de-
sired station.
Turn to change the station; press to select.
# You can also change the station by pushing
MULTI-CONTROL up or down.
# To store the currently received frequency in
memory, press and hold MULTI-CONTROL until
the selected preset number stops flashing.
# To return to the frequency display, press
BAND/ESC.
Tuner
En
16
Section
04