Pioneer SUPER TUNERIII DEH-P8650MP - Manual (Page 55)

! The time alignment value calculated by
auto TA and EQ may differ from the actual
distance in the following circumstances.
However, the distance has been calculated
by computer to be the optimum delay to
give accurate results for the circum-
stances, so please continue to use this
value.
When the reflected sound within a vehi-
cle is strong and delays occur.
When delays occur for low sounds due
to the influence of the LPF on active
subwoofers or external amps.
! Auto TA and EQ changes the audio settings
as below:
The fader/balance settings return to the
center position. (Refer to page 45.)
The graphic equalizer curve switches to
FLAT. (Refer to page 51.)
When a subwoofer is connected to this
unit, it will be adjusted automatically to
both subwoofer output and high pass fil-
ter setting for rear speaker.
! Ifyou carry out auto TA and EQ when a pre-
vious setting ofthis already exists, the set-
ting will be replaced.
Carryingout auto TA and EQ
1 Stop the car in a place that is as quiet
as possible, close all doors, windows and
the sun roof, and then turn the engine off.
Ifthe engine is left running, engine noise may
prevent correct auto TA and EQ.
2 Fix the supplied microphone in the cen-
ter of the headrest of the drivers seat, fa-
cing forward, using the belt (sold
separately).
The auto TA and EQ may differ depending on
where you place the microphone. Ifdesired,
place the microphone on the front passenger
seat to carry out auto TA and EQ.
3 Turn the ignition switch to ON or ACC.
Ifthe cars air conditioner or heater is turned
on, turn it off. Noise from the fan in the air
conditioner or heater may prevent correct auto
TA and EQ.
# Press SOURCE to turn the source on ifthis
unit is turned off.
4 Select the position for the seat on
which the microphone is placed.
Refer to Using the position selector on page
44.
# Ifno position is selected before you start auto
TA and EQ, Front Left is selected automatically.
5 Press SOURCE and hold until the unit
turns off.
6 Press and hold EQ to enter the auto TA
and EQ measurement mode.
The front panel opens automatically.
7 Plug the microphone into the micro-
phone input jack on this unit.
8 Press MULTI-CONTROL to start the auto
TA and EQ.
Audio Adjustments
En
55
English
Section
10