POSIFLEX Business Machines PST KB136 - Manual (Page 26)

4 - 8
TM
any other key stoke – will be taken as an input in ASCII-code editing mode.
COMMAND LISTING IN SCAN CODE
EDITING MODE
ESC – leading code to enter scan code of any key after it into key-content, except
“ESC” + “F” for utility version since 2.15.xx
ESC-F – leading code of arbitrary release code for utility version since 2.15.xx.
usually used to release “CTL”, “ALT” or “SHF”.
F1 – get help on command list of ASCII- code editing mode
F5 – enter view mode
F8 – enter view mode
F10 – enter view mode
BkSp – delete the character to the left of cursor
Ins – toggle insert/overwrite status for editing (default = insert)
Del – delete the character where cursor stays or the last character
Home – go to first position within the key definition
End – go to last position within the key definition
PgUp – go to one page less in cyclic manner
PgDn – go to one page next in cyclic manner
Up arrow – move cursor to one row up in cyclic manner and enter view mode
Down arrow – move cursor to one row down in cyclic manner and enter view mode
Left arrow – move cursor to one character left within the key definition
Right arrow – move cursor to one character right within the key definition
Alt-A – enter view mode
Alt-D – enter time delay mark into the key-content
Alt-M – enter a multi-level shift marker into the key-content
Alt-N – enter view mode
Alt-S – enter a multi-level separator between definitions of different levels.
Alt-X – enter view mode
Alt-27 – work like “ESC” as the leading code for scan codes.
Alt-8 – enter a “BkSp” into the key-content
Ctl-C – immediately terminates the programming utility.