POSIFLEX Business Machines PST KB136 - Manual (Page 25)

4 - 7
TM
Alt-W – write key definitions to the programmable keyboard
Alt-X – quit the keyboard programming program
any other key stoke – will be taken as an input in ASCII-code editing mode, and will
give no influence if the current key was last edited in scan-
code editing mode
COMMAND LISTING IN ASCII-CODE
EDITING MODE
ESC – enter view mode
F1 – get help on command list of ASCII- code editing mode
F5 – enter view mode
F8 – enter view mode
F10 – enter view mode
BkSp – delete the character to the left of cursor
Ins – toggle insert/overwrite status for editing (default = insert)
Del – delete the character where cursor stays or the last character
Home – go to first position within the key definition
End – go to last position within the key definition
PgUp – go to one page less in cyclic manner
PgDn – go to one page next in cyclic manner
Up arrow – move cursor to one row up in cyclic manner and enter view mode
Down arrow – move cursor to one row down in cyclic manner and enter view mode
Left arrow – move cursor to one character left within the key definition
Right arrow – move cursor to one character right within the key definition
Alt-A – enter view mode
Alt-D – enter time delay mark into the key-content
Alt-N – enter view mode
Alt-S – enter a multi-level separator between definitions of different levels.
Alt-X – enter view mode
Alt-27 – enter an “ESC” into the key-content
Alt-8 – enter a “BkSp” into the key-content
Ctl-C – immediately terminates the programming utility.