Philips FW P880 - Manual (Page 12)

12
English
3139 115 20421
➜ "TEST TONE" followed by "ADAPT
BALANCE, CENTER AND REAR LEVEL" will
be displayed.
➜ The test signal will last for about 90 seconds.
Adjust the sound level
BALANCE
CENTER REAR
DPL TEST TONE
L R
+ - + -
Front speakers
● Press BALANCE L on the remote control for
left speaker and press BALANCE R on the
remote control for right speaker.
➜ "BAL L +XX" or "BAL R +XX" will be
displayed.
Center speaker
● Press CENTER + or - on the remote
control.
➜ "CENT +XX" or "CENT-XX" will be displayed.
Surround speakers
● Press REAR + or - on the remote control.
➜ "REAR +XX" or "REAR -XX" will be
displayed.
To switch off the TEST TONE
● Press TEST TONE.
Notes:
– It is advisable to set the speakers’ level at
normal listening level.
– "
XX" denotes the sound level.
Switching the Dolby Pro Logic
● Press DPL (PRO LOGIC)
repeatedly to select and cycle
through the various sound
modes.
➜ The Dolby Pro Logic display
panel will light up with the
selection.
Dolby Surround ➜ Dolby Center Phantom
➜ Dolby 3 Stereo ➜ Stereo ➜ Dolby
Surround …
Dolby Surround
This setting is for a full
Dolby Surround Pro Logic
mode.
➜ “DOLBY SURROUND”
will be displayed.
Dolby Center Phantom
This setting is for use
without the center speaker.
It redistributes the center
speaker sound to the left
and right speakers,
providing conventional
stereo across the front.
➜ “DOLBY CENTER PHANTOM” will be
displayed.
Dolby 3 Stereo
Use this setting when full
surround is not required,
but a wide stereo sound is
desired. It requires only the
left, right and center
speakers.
➜ “DOLBY 3 STEREO” will be displayed.
Normal Stereo
This setting is for normal
stereo sound without
Dolby Pro Logic. It requires
only the left and right
speakers.
➜ “STEREO” will be
displayed.
Dolby Pro Logic
LEFT CENTER RIGHT
SURR SURR
LEFT CENTER RIGHT
SURR SURR
LEFT CENTER RIGHT
SURR SURR
LEFT CENTER RIGHT
SURR SURR
DPL TEST T
PRO LOGIC
pg 001-032/P880/37-Eng 12/8/00, 1:54 PM 12