Pioneer DV-667A-S - Manual (Page 83)

Additional information 10
83
En
No picture/No color. • Incorrect video connections: Check that connections are correct
and that plugs are inserted fully. Also check the video cable for
damage.
• TV/monitor or AV amplifier settings are incorrect: Check the
instruction manual of the connected equipment.
• The video output is set to progressive but your TV/monitor is not
compatible with progressive scan: See
page 56 for how to set to
interlace.
• When set to progressive video output, there is no video output from
the composite or S-video outputs.
Screen is stretched or
aspect does not change. • The TV Screen setting in the Initial Settings menu is incorrect. See
page 72 for how to set it correctly for your TV/monitor.
• If your TV/monitor is connected using an S-video cable, try changing
the
S-Video Out setting ( page 58 ).
Picture disturbance
during playback or the
picture is dark. • This player is compatible with Macro-Vision System copy guard.
Some discs include a copy prevention signal, and when this type of
disc is played back, stripes etc., may appear on some sections of the
picture depending on the TV. This is not a malfunction.
• Due to the player’s copy protection circuits, connection of this
device through a VCR or an AV selector may prevent recording or
cause picture problems. This is not a malfunction.
• The TV system may be set inappropriately. See Setting the TV
System on
page 81 .
No audio, or audio is
distorted. • No audio is output during slow motion playback or when scanning
discs other than audio CDs
• Some DVD discs do not output digital audio: Switch your amplifier
to the player's analog outputs.
• Check that the disc is free from dust and dirt, and that it is not
damaged (
page 70 ).
• Check that all interconnects are firmly inserted.
• Check that the plugs and terminals are free of dirt, oxide, etc. and
clean if necessary. Also check the cable for damage.
• Make sure the player's output is not connected to the amplifier's
phono (turntable) inputs.
• Check your amplifier/receiver’s settings (volume, input function,
speaker settings, etc.).
The analog audio is OK,
but there appears to be
no digital audio signal. • Make sure that the Digital Out setting is set to On ( page 54 ).
• Check that the Dolby Digital, DTS and MPEG out settings
(
pages 55 – 56 ) are suitable for your amplifier/receiver—check the
instruction manual that came with your amplifier/receiver.
• SACDs and some DVD-Audio discs do not output digital audio.
Listen through the player’s analog audio outputs.
Problem Remedy
DV563.book 83 ページ ２００３年４月２５日 金曜日 午後８時１１分