Paxar Avery Dennison TC9416CTIUM - Manual (Page 20)

2-8 User Manual
S e t t i n g t h e P r i n t P o s i t i o n
This function adjusts where data prints vertically on the supply. Adjust
the print if it is too close to the top or bottom of the supply, or overtypes
the pre-printed area. The adjustments are in dots (0.0049 inch). The
range is -99 to +99 and the default is 0.
♦ If the data is too close to the bottom, increase the number.
♦ If the data is too close to the top, decrease the number.
1. From the Config Menu, press
← or → until you see
12. Set Print Position
2. Press Enter. You see
Enter print pos
[-99/99] +0
3. Press ← or → to change the contrast in increments of 1 dot.
Press ↑ or ↓ to change the contrast in increments of 10 dots.
Pressing ← or ↓ decreases the value (moves the image down);
→ or ↑ increases it (moves the image up).
4. When you are finished, press Enter. You return to the
Config Menu.